Barnett Quad Edge Crossbow

The Quad Edge keeps the four-limb, parallel-limb layout that defined the Quad 400 - a magnesium riser with laminated limbs rather than the usual two-limb compound build - but updates the stock and trims weight for a faster shot: 340 FPS on the standard model and 350 FPS on the Quad Edge S, against the Quad 400's 345 FPS. Barnett also lightened the trigger to roughly 3.5 lbs with a redundant spring-loaded safety bar as part of its Anti Dry Fire system.

Dimensions are close to the Quad 400's but not identical - 36 inches overall and 21 inches axle-to-axle uncocked, at the same 6.9-lb weight. Sources disagree slightly on draw weight and kinetic energy between the standard model and the S variant, which is typical for a current package sold through multiple retailers rather than one standardized listing.

There is no Hyper in the Quad Edge's name, so it takes standard-diameter Headhunter bolts rather than the narrow Hyperflite shaft - the package ships with three 22-inch carbon arrows.

The string length confirms the fit independently of the name: aftermarket makers cut the Quad Edge's bowstring at 37.9375 inches with 21.6875-inch cables - close to, but distinct from, the Quad 400's 39.625-inch string, so the two are not interchangeable despite the shared Quad name and bolt family. See the fit by model page for both.

Unlike the rope-cocker-equipped Quad 400, the Quad Edge does not ship with any cocking device - owners add a basic rope cocker or a crank cocking device separately, and the stock supports mounting one. At 125-150 lbs of draw, a rope cocker is manageable for most shooters, but a crank is worth the extra cost if shoulder or back strength is a concern.

The Quad Edge is a current Barnett package sold through several archery and outdoor retailers; it does not have a confirmed live Amazon listing at the time of writing. What is reliably available: 22-inch Headhunter bolts, rope cockers and cranks, and lube wax.

If buying secondhand, check the limbs, cams and rail the same way you would on any Barnett - those structural parts are not made aftermarket. Either way, re-zero the scope at 20 yards before the first hunt; the sighting-in guide covers the order that avoids wasted bolts.